Three-phase voltage stabilizer HERTZ-PRO U 36-3/160 v3.0
The three-phase voltage stabilizer Hertz-PRO is designed to operate in electrical networks with voltage fluctuations from 150 to 260V. In this range, the device is guaranteed to deliver a voltage at the output within 220 ± 1%, which is ensured through the use of 36 stabilization steps, respectively. The Hertz-PRO model range in terms of power can be 66, 83 and 106 kW, which corresponds to an operating current of 100, 125 and 160A per phase.
The features of this stabilizer include a double LED indicator per phase, a linear loading strip, the presence of a mechanical transit (bypass), floor-standing design, the presence of input and output filters to protect against high-frequency interference, silent operation due to the use of toroidal transformers and thyristor switches.
If it is necessary to obtain a voltage different from 220V in Hertz at the output of the stabilizer, there is a function of adjusting this value in the range of 200-230V. In manual mode, you can change the output voltage in 1V steps. In this case, the changes will be applied simultaneously to all phases.
The Hertz stabilizer has the ability to manually adjust the lower shutdown threshold (60-135V). This function is in demand for a load with high inrush currents, at startup of which a strong voltage drop and emergency shutdown of the stabilizer are possible. When this option is activated, the stabilizer will make it possible to start any engine or pump within a minute, even if the voltage drops to 60V in the network.
The built-in phase synchronization mode will instantly disconnect a three-phase load, protecting it from power outages and loss of power on phases (one or two). This function is manually operated and therefore can be disabled at any time. In this case, the phases will work independently of each other.
It is recommended to install and operate the Hertz stabilizer in dry and heated rooms. This unit is designed for floor standing installation. The connection is made to the existing wiring through the terminal block.
Operating current, A |
3 × 160 |
Rated power, kVA / kW |
106 |
Number of stabilization steps |
36 |
Key type |
thyristor |
The efficiency of the stabilizer is not lower,% |
98 |
Active power consumption at idle, no more, W |
20 |
Nominal output voltage, V |
220 |
Minimum operating input voltage, V |
100 |
Maximum input operating voltage, V |
280 |
Output voltage regulation, V |
200-230 |
Adjustment of the lower threshold of shutdown, V |
60-135 |
Accuracy in the stabilization range,% |
1 |
Response time to changes in input voltage, ms |
20 |
Power supply frequency, Hz |
45-65 |
Input Current and Apparent Power Measurement |
yes |
Short-circuit and overload current limitation |
input circuit breaker with C-characteristic electromagnetic protection |
Mechanical Bypass |
yes |
Network and Stabilizer Condition Analyzer |
yes |
Duplicate overvoltage protection |
yes |
Microcontroller control |
yes |
Input choke |
yes |
Output choke |
yes |
Overheating protection |
yes |
Minimum cable cross-section for connection, mm² |
25 |
Maximum cross-section of cable conductors for connection, mm² |
40 |
Forced Cooling |
two speed fan |
Overall dimensions, mm, no more |
1280х384х779 |
Weight, kg, no more |
265 |
Warranty, years |
7 |
]]>